C2000ware 5.02 地址变量为：COM_TI_C2000WARE_INSTALL_DIR，CCS12.2以上版本能够直接匹配识别！ 但是C2000ware4.03版本地址变量为：COM_TI ...

dac_trigger.SOFT_RESET = 10; // 当设置为保留码A(1010)时，该位复位设备到默认状态。这些位是自我复位的。 dac_trigger.LDAC = 0; // 将此位设置为1，以同步模式同步加载DAC，此位是自复位。 dac_send_data(DACx0501_TRIGGER, dac_trigger.Trigger); dac_sync.DAC_SYNC_EN ...

设置SPI多个片选引脚除了config里面定义的其余引脚是否需要用GPIO虚拟，同时虚拟出来的引脚对传输速率是否有影响 可以使用GPIO模拟，在每次SPI发送之前，对SPI的片选信号也会进行控制，所以SPI的片选信号就是在每次需要发送到某个设备的时候，将CS片选端进行 ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask ...

Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask ...

Texas Instruments (TI) Audio support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search audio IC content or ask ...

Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC ...

Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask ...

I am searching for a pspice model of the LM741 with modeled offset-pins. In the circuit I have to rebuild in Pspice, the offset pins are connected to a potentiometer. And the third pin of the ...

Company L3 TRL in UK need some support on "SERIAL-BUS-EVM" , if this is not the right forum then please point me to the right forum: "We want to use the 'Serial Bus ...

we are trying to integrate in our FPGA kintex-7 XC7K70T-1 the Xilinx DisplayPort RX Subsystem v2.1 to receive a DP1.2 flow. (our application requires to send the flow to two MiniDisplays). We need to ...